-
Jan 26,2024
Introduction of Common Defective Glass Beads Ⅰ.Oval glass beads (see Figure 1) When the ratio of the major diameter D to the minor diameter d is greater than 1.3 (D/d >1.3), the oval glass bead shall be considered defective. Figure 1- Oval Glass Beads Ⅱ. Satellites (see Figure 2) When a ...
read more
-
Mar 11,2024
Why Are the Road Markings Not Removed and Repaved, but Repainted and Covered with Glass Beads? For a number of reasons, road markings are usually scattered with glass beads and repainted rather than removed and repaved. Cost-effectiveness: In general,Repainting road markings and scattering glass beads is far less expensive than removing and repaving the road. This is due to the fact that re...
read more
-
Mar 29,2024
What Is Real High Reflective Road Marking? Road Marking owns a long history and plays a crucial role in traffic safety by giving out people’s warning so as to protect them from accidents, and that’s exactly the reason why the high reflectivity of the road marking should be stressed. But do you really understand what real High Reflective Road Marking is? According to China’s latest standards for ro...
read more
-
Apr 02,2024
Introduction of Common Defective Glass Beads Ⅰ.Oval glass beads (see Figure 1) When the ratio of the major diameter D to the minor diameter d is greater than 1.3 (D/d >1.3), the oval glass bead shall be considered defective. Figure 1- Oval Glass Beads Ⅱ. Satellites (see Figure 2) When a glass bead supports more than two smaller glass beads, called satellites, or when, in the case of two satelli...
read more
-
Apr 12,2024
How to Solve Bubbles in Road Markings? All roads should be clean and dry during the marking construction. Moisture is the most harmful factor in the adhesion of paint and pavement. The amount of moisture in the ground is enough to affect proper coating adhesion. Early morning dew and fog usually result in wet roads. If there is too much moisture on the road surface, it usually leads to blistering ...
read more
-
Apr 28,2024
Detailed Process of Hot Melt Marking Construction 1. Road Cleaning Before construction, the nearby area must be cleaned to ensure that there are no impurities such as oil, water, fallen leaves, weeds, etc., so as not to affect the adhesion, smoothness, and reflective effect of the markings. 2. Full Scale Plotting During the setting out process, calculations and ...
read more
-
May 10,2024
Common Problems about Hot Melt Paint Construction in Summer 1. Precautions for hot melt paint construction in summer Hot-melt paint, as the name implies, melts when exposed to heat. (Substances that are solid at room temperature melt at a certain temperature and become liquid, which is called molten state.) According to the current Chinese national standard Road Marking Paint JT/T280-2004, the sof...
read more